ATEN Technology IOGEAR GWSSKIT Wireless Screen Sharing and Miracast Kit User Manual

ATEN Technology, Inc., dba IOGEAR Wireless Screen Sharing and Miracast Kit

User Manual

GWSSKIT-Q1442-a_062918.indd   1Wireless Screen Sharing and Miracast Kit
3Introduction 4Features 4Package Contents  5System Requirements  5Overview 6Hardware Installation  7Software Installation  18Compliance Information  21Limited Warranty  21Contact 21GWSSKIT-Q1442-a_062918.indd   2-3
4 5GWSSKIT-Q1442-a_062918.indd   4-5
DC 5VMODEDC 5VMODE6 7GWSSKIT-Q1442-a_062918.indd   6-7
8 9DC 5VMODEGWSSKIT-Q1442-a_062918.indd   8-9
10 11GWSSKIT-Q1442-a_062918.indd   10-11
12 13GWSSKIT-Q1442-a_062918.indd   12-13
14 15GWSSKIT-Q1442-a_062918.indd   14-15
16 17GWSSKIT-Q1442-a_062918.indd   16-17
18 19GWSSKIT-Q1442-a_062918.indd   18-19
20 21GWSSKIT-Q1442-a_062918.indd   20-21
22FCC Warning:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:o Reorient or relocate the receiving antenna.o Increase the separation between the equipment and receiver.o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.o Consult the dealer or an experienced radio/TV technician for help.Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be located or operating in conjunction with any other antenna or transmitter."To comply with FCC RF exposure compliance requirements, this grant is applicable to only mobile configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter."Note:This device should be used for indoor only.GWSSKIT-Q1442-a_062918.indd   22

Navigation menu