Coppernic C-ONE-E-ID Mobile Terminal User Manual

Coppernic Mobile Terminal

Contents

User Manual

C-One e-ID User Manual
- 2 - 1. Product description The C-One e-ID is a 4G biometric mobile device able to read all secure ID documents. 2. How to charge the C-One e-ID The C-One e-ID can be charged with a Micro USB cable through PC.
- 3 - 3. How to insert and remove Micro SIM card(s) into the C-One e-ID INSERTION a. Open the Dual Micro SIM door b. Use a paperclip to open the SIM tray c. Insert the Micro SIM card(s) into the slot (1&2) d. Close and press the Dual Micro SIM door after installation REMOVAL e. Open the Dual Micro SIM door f. Use a paperclip to open the SIM tray g. Remove the Micro SIM card(s) h. Close and press the Dual Micro SIM door after removal
- 4 - 4. How to insert and remove Micro SD card into the C-One e-ID INSERTION i. Open the Micro SD door j. Insert the Micro SD card into the slot as described below k. Close and press the Micro SD door after installation REMOVAL • Open the Micro SD door • Use a tweezers to remove the Micro SD card • Close and press the Micro SD door after removal
- 5 - 5. Data capture to use on the C-One e-ID SCAN A BARCODE WITH THE IMAGER TAKE A PICTURE WITH THE CAMERA
- 6 -
- 7 - DECODE A FINGERPRINT INSERT SAM
- 8 - INSERT AND READ A SMARTCARD
- 9 - READ A CONTACTLESS CARD
- 10 - 6. How the C-One e-ID communicates with computer a. Plug USB cable into C-One e-ID and PC b. On PC, use file explorer to access the device. 7. RFID Regulatory Information FCC INFORMATION TO USERS Radiation Exposure Compliance. This product complies with the FCC RF exposure limits for an uncontrolled environment. FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
- 11 - INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. CE MARKING Please CE marking and details of other country markings refer to the Declaration of Conformity (Doc) at http://www.coppernic.fr

Navigation menu