Datalogic S r l 0033 POCKET-SIZED MOBILE COMPUTER User Manual DL Memor Regulatory Addendum

Datalogic ADC S.r.l. POCKET-SIZED MOBILE COMPUTER DL Memor Regulatory Addendum

Contents

Users Manual Addendum

DL-Memor™ Regulatory Addendum RF EXPOSURE INFORMATION (SAR) This model device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the device is designed to operate at multiple power levels so as to use only the poser required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. The highest SAR value for the model device as reported to the FCC are the following: − DL-Memor + 802.11g + BT models: for use at the head is 0.029 W/kg and when worn on the body, as described in the user guide, is 0.00412 W/kg. (Body-worm measurements differ among device models, depending upon available enhancements and FCC requirements); − DL-Memor + EdgeA + BT models: for use at the head is 1 W/kg (GSM 850 Band) and 1.08 W/kg (GSM 1900 Band). When worn on the body, as described in the user guide, is 0.79W/kg (GSM 850 Band) and 0.198W/kg (GSM 1900 Band). (Body-worm measurements differ among device models, depending upon available enhancements and FCC requirements). While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirement. 852000500 The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on the below FCC IDs: FCC ID: U4G0030 for DL-Memor+802.11g+BT models; FCC ID: U4G0033 for DL-Memor+EdgeA+BT models. This device is compliant with SAR for general population /uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had been tested in accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C. For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and the positions the handset a minimum of 1.5 cm from the body. Use of other enhancements may not ensure compliance with FCC RF exposure guidelines. If you do not use a body-worn accessory and are not holding the device at the ear, position the handset a minimum of 1.5 cm from your body when the device is switched on. INDUSTRY CANADA COMPLIANCE Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES- 003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. The County Code Selection feature is disabled for products marketed in the US/Canada. IMPORTANT NOTE: IC Radiation Exposure Statement This EUT is compliant with SAR for general population/uncontrolled exposure limits in IC RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528. This equipment should be installed and operated with minimum distance 1,5cm between the radiator & your body. CTIA COMPLIANCE∗ − Do not disassemble or open crush, bend or deform, puncture or shred. − Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids, expose to fire, explosion or other hazard. − Only use the battery for the system for which it is specified. − Only use the battery with a charging system that has been qualified with the system per this standard. Use of an unqualified battery or charger may present a risk of fire, explosion, leakage, or other hazard. − Do not short circuit a battery or allow metallic conductive objects to contact battery terminals. − Replace the battery only with another battery that has been qualified with the system per this standard, IEEE-Std-1725- 2006. Use of an unqualified battery may present a risk of fire, explosion, leakage or other hazard. − Promptly dispose of used batteries in accordance with local regulations. − Battery usage by children should be supervised. − Avoid dropping the phone or battery. If the phone or battery is dropped, especially on a hard surface, and the user suspects damage, take it to a service center for inspection. − Improper battery use may result in a fire, explosion or other hazard. − The device shall only be connected to products that bear the USB-IF logo or have completed the USB-IF compliance program. ∗only applicable to EdgeA + Bluetooth® models

Navigation menu