EXPORTPRO TECHNOLOGY MT-301 Digital Proportional System User Manual 1

SHENZHEN EXPORTPRO TECHNOLOGY CO., LTD Digital Proportional System 1

15_MT-301 UserMan

MT-301TXMT-301TX MT-301RX7.4~11.1V(Li-poly3S)MT-301RXMT-3016.0~8.4V(Ni-cd)
2Do not mix alkaline batteries, standard(carbon-zinc) or rechargeable(Nickel-Cadmium) batteriesWorking Station Indicator
3VCCCH3BINDCH2CH1MT-301RXMT-301RX
Steering Trim LeverCH1Throttle Trim LeverCH2Steering D/R LeverD/RThrottle EPA-         + -         +4MT-301RX1)Press and hold the bind button on the receiver and then turn the receiver on, the LED indicator flashes quickly.   Now the receiver is in the binding mode, then loosen the button.2)Turn the tramsmitter on, it will bind with the receiver automatically. It shows the binding process is sucessful,   if the LED indicator on the receiver is continuesly lit.If it is not sucessful because of long binding distance,  Under the situation of the binding sucessfully, press and hold the bind button for 2 seconds, it comes to fail-safe   setup for 5 seconds, the LED indicator flashes quickly and it will come back to the normal mode once it the  process is over. During the process of fail-safe setup, choose 3CH when out of control and then wait the receiver comes back to  the normal mode.   turn the transmitter off and then turn it on once again.(Do not keep the reciever far away from the transmitter   when binding.)FAIL-SAFE SETUP'S PROCEDURE
 FCC STATEMENT This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.  Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.  NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:    Reorient or relocate the receiving antenna.    Increase the separation between the equipment and receiver.    Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.    Consult the dealer or an experienced radio/TV technician for help.        5

Navigation menu