Konftel RMT Konftel Remote Control User Manual

Konftel AB Konftel Remote Control

User Manual

www.konftel.com Konftel AB, Box 268, SE-901 06 Umeå, SwedenTel: +46 90 706 489 Fax: +46 90 131 435 info@konftel.com110248-61-001 Rev 1CKonftel Remote Control SpecicationsRF carrier frequency 433.92 MHzDimensions (W x H x L) 54 x 190 x 25 mmUnit weight (excl. batteries) 90 gBattery type AAA x 3 pcsINSTALLING BATTERIES Three AAA batteries are required for operation. Remove the battery cover. Check the polarity of the batteries and the “+/-” marks inside the battery compartment. Insert the batteries following the marks. Push the battery cover back in place. Battery safety• Usenewbatteriesoftherecommendedtypeand size only. Risk of explosion if battery is replaced by an incorrect type.• Donotmixoldandnewbatteries.• Tohelpavoidthechanceofchemicalleaksremove the batteries from the remote if you do not intend to use the remote for an extended period of time.• Disposeofoldbatteriesproperly.Donotburnor bury them.PAIRING Select MENU > SETTINGS > REMOTE CONTROL on the conference phone. Press OK to set the conference phone in pairing mode. Press the and buttons on the remote control simultaneously for three seconds. The red LED on the remote control starts ashing and a pairing conrmation appears on the confe-rence phone display.  Press OK on the conference phone to conrm that you want to pair the units.FCC statements1) Caution: Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.2) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.IC statementsThis device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouil-lage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Navigation menu