Nortek Security and Control 2GIG RPTR1345 Wireless 345MHz Repeater User Manual Recessed Door Contact Installation Instructions

2GIG Technologies, Inc. Wireless 345MHz Repeater Recessed Door Contact Installation Instructions

User Manual

Copyright © 2016 Nortek Security & Control LLC 1 2GIG-RPTR1-345WIRELESS INDOOR REPEATERINSTALLATION INSTRUCTIONSThe2GIGWirelessIndoorRepeater(2GIG‐RPTR1‐345)isaremotelypoweredwirelessindoorrepeater.Therepeaterisaperipheraldevicethatcommunicateswiththe2GIGPanelusingaproprietary345MHztransmissionprotocol.Therepeaterreceivesandrecognizesmessagesfromother345MHzdevicesthatareunabletodirectlycommunicatewiththesystem,and“repeats”thosemessagestoextendtherangeofthesedevices.Therepeaterwilltypicallybeinstalledatthemid‐pointbetweenthepanelandthewirelessdevicesbeingrepeated.Whenatransmissionfromadeviceisrepeated,therepeateraddsabittothemessagetoindicatetothesystemthatthemessageisnotcomingdirectlyfromthedevice.Therepeaterwillnotrepeatalreadyrepeatedmessages.TherepeaterispoweredbyanACadapterandisequippedwitharechargeablebatterywhichsupports24hoursofbatterybackupunderconditionsoflocalpowerfailure.WhenthepowersourcefortherepeaterchangesfromACpowertobatterybackup,orfrombatterybackuptoACpower,therepeaterwillautomaticallysendamessagetothesystemwithintwo(2)minutes.Inaddition,supervisorymessagesaresentapproximatelyevery70minutesthatindicatetherepeaterstatus.TherepeaterisequippedwithastatusindicatorLEDvisiblefromthefrontoftheunit,andalearnbuttonislocatedonthesideoftheunit.Figure 1 WirelessIndoorRepeaterPackageContentsInstalling the BatteryTherechargeablebatterycanbeinstalledbyopeningtheenclosurewhilethepowerisdisconnected(seeFigure2).WARNING: Polarityofthebatterymustbeobserved.Alignthebatterytomatchthepolarityindicatorsonthecircuitboard.Improperinstallationofthebatterymayresultinheatgeneration,explosion,orfirewhichmayleadtopersonalinjury.Installing the RepeaterFigure 2 Wireless Indoor Repeater Component and Feature LocationsMounting GuidelinesUsetheseguidelineswheninstallingthewirelessindoorrepeater:•MountRepeaterswithin100ft(30m)oftheControlPanel.Althoughthetransmittermayhavearangeof350ft(106.7m)inopenair,therepeaterlocationcanhaveasignificanteffectonrange.Inopen/unobstructedsituations,thetransmitterrangemaybegreater.Inadversewirelessconditions,changingtherepeaterorientationmayleadtoimprovedrange.•MountRepeatersashighaspossible.Mountingtherepeaterhighoffthegroundhelpsreceiversensitivity.•DoNotExposeRepeaterstoMoistureorExtremeTemperature.Itisbesttomountrepeatersinadrylocationwheretheoperatingtemperaturedoesnotexceed32°to120°F(0°to49°C).•KeepRepeatersAwayfromMetal/MetalicSurfaces.Tokeeptherepeaterawayfrommetalormetallicsurfaces(forexample,foilwallpaper),itisrecommendedthatyouusespacers(notincluded).Youshouldalsoavoidmountingsensorsinareaswherethereisalargequantityofmetalorelectricalwiring(forexample,nearafurnaceorinautilityroom).Toinstallthewirelessrepeater:1Opentherepeatercase.2Attachthebasetothedesiredwalllocationwiththefour(4)Phillipsheadscrewsandanchorssupplied(seeFigure2).3Installthetamperscrew(seeFigure2).Withthetamperscrewinstalled,removingthecasefromthewalltriggerstamper.NOTE: Forthetampertoworkcorrectly,thetamperscrewmustbeinstalledintoawallstud.Donotuseawallanchor.4Installthebattery.Observebatterypolarity.5Connectthe2‐conductorwiretothepowersupplyandtotheterminalconnectoronthecircuitboard.Makesurethewirepassesthroughthegrommetandholeontherepeaterbasebeforeconnectingtotheterminal.6AttachtherepeatercovertothebaseandsecuretheassemblywiththePhillipsheadcaselockingscrew.ARechargeableLithium‐IonBatteryBACAdapterCTamperScrewDMountingScrewsandAnchors(4)ELearnButtonFStatusIndicatorGPowerInputHCaseLockingScrewHGFEBACD1RechargeableLithium‐IonBattery 6RepeaterBase2TamperSwitch 7TamperScrew3Repeater 8MountingScrews(4)4PowerInputConnector 9MountingAnchors(4)5LearnButtonOBSERVEBATTERYPOLARITY 123456789PRINTER’S INSTRUCTIONS10012437A-2GIG-RPTR1-345-INSTALL-INSTR-en-PRT, 09/16/2016, BLACK, 20LB MEAD BOND, 8.5X11”, TOL. +/- 0.125, SCALE: 1:1, FRONT & BACK, FOLD TO FIT BOX
2 Copyright © 2016 Nortek Security & Control LLCWireless Indoor Repeater Installation Instructions7PlugtheACadapterintoanACoutlet.Thestatusindicatorwillemitasteadygreenlight.NOTE: DonotconnecttheACadaptertoanACoutletthatiscontrolledbyaswitch.8Oncetherepeaterispoweredup,itbeginsrepeatingallunrepeated345MHz2GIGtransmissions.Status IndicationsThestatusindicatorshowstherepeaterstatusasfollows:•SteadyGreen:TherepeaterisACpowered,andthebackupbatteryisgood.•SolidRed:TamperorACpowerfailure.•SlowFlashingRed:Lowbattery.•FastFlashingRed:Jammed.•Blinkoff:Transmissionreceived.SPECIFICATIONSOverallSize 102X76X46mm(4.0”X3.0”X1.8”)Material High‐impactABSplasticColor WhiteWeight(withoutbattery) 125g(4.4oz.)InstallationType WallmountedOperatingFrequency 345MHzOperatingTemperatureLimits ‐10°Cto55°C(14°Fto131°F)RelativeHumidity 5to85%non‐condensingPowerType RemotelypoweredbyACadapter,withinternalbatterybackupACAdapterNominalInputVoltage 100–240VAC50/60HzACAdapterNominalOutputVoltage 14VDCMaximumPowerConsumption 3WIdleCurrent 40mAOperatingCurrent(repeating) 75mAStorageDeviceCapacity 800mAh(1)3.7V800mAh14500TypeLi‐ionbattery(nottobereplaced)REPEATER OPERATIONAND MESSAGE DESCRIPTIONSSupervisoryMessage:•Therepeatergeneratesasupervisorymessageevery70min±10min.Themessagecontainsthecurrentbatterystatusandtamperstate.PowerUp:•Whentherepeaterisfirstpoweredup,amessageisgeneratedcontainingthecurrentbatterylevelandtamperstate.TamperMessage:•Whentherepeaterdetectstamper,amessageissentcontainingtherepeaterstate,tamperstate,andbatterylevel.EventMessage:•Whentherepeaterreceivesamessage,themessageisregeneratedwithanindicationthemessagehasbeenrepeated.REGULATORY INFORMATION2GIG1950CaminoVidaRoble,Suite150Carlsbad,CA92008USAFortechnicalsupportintheUSAandCanada:855‐2GIG‐TECH(855‐244‐4832)Email:2gigtechsupport@linearcorp.comVisitwebsitefortechnicalsupporthoursofoperationFortechnicalsupportoutsideoftheUSAandCanada:ContactyourregionaldistributorVisit2gig.com/dealers/foralistofdistributorsinyourregionANortekCompany10012437AWARNING: ThisdeviceisnotdesignedtorepeatsignalsfromlifesafetydevicessuchasSmokeorCOdetectors.This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec on against harmful interference in a residen al installa on. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instruc ons, may cause harmful interference to radio communica ons. However, there is no guarantee that interference will not occur in a par cular installa on. If this equipment does cause harmful interference to radio or television recep on, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.Reorient or relocate the receiving antennaIncrease the separa on between the equipment and receiverConnect the equipment into an outlet on a circuit diff erent from that to which the receiver is connectedConsult the dealer or an experienced radio/TV technician for help.Any changes or modifi ca ons not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. Ľexploita on est autorisée aux deux condi ons suivantes: (1) ľappareil ne doit pas produire de brouillage, et (2) ľu lisateur de ľappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscep ble ďen comprome re le fonc onnement.FCC COMPLIANCE STATEMENTThis device complies with FCC Rules and Regula ons as Part 15 devices as well as Industry Canada license exempt RSS Rules and Regula ons. Opera on is subject to the following two (2) condi ons: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired opera on.LIMITED WARRANTYThis Nortek Security & Control LLC product is warranted against defects in material and workmanship for two (2) years. This warranty extends only to wholesale customers who buy direct from Nortek Security & Control LLC or through Nortek Security & Control normal distribu on channels. Nortek Security & Control does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any.There are no obliga ons or liabili es on the part of Nortek Security & Control for consequen al damages arising out of or in connec on with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profi t, or cost of removal, installa on, or reinstalla on. All implied warran es for func onality, are valid only un l the warranty expires. This Nortek Security &Control Warranty is in lieu of all other warran es expressed or implied.

Navigation menu