SHARPVISION DW132671CAI 7 inch Digital Wireless System User Manual CGZ3140823 00959 EF DW671

SHARPVISION CO.,LTD. 7 inch Digital Wireless System CGZ3140823 00959 EF DW671

User Manual

Image DeviceTV System PAL NTSCEffective PixelsSensing AreaScanning SystemSync. SystemHorizontal Sync Frequency 15.625 kHz 15.734 kHzVertical Sync Frequency 50 Hz 60 HzVideo OutputGamma ConsumptionAGCS/N RatioWhite BalanceElectronic ShutterBLCOperation Frequency: Line of Sight Range:Receiving Sensitivity:Video Codec: Frame Rate:Output Power: Spread SPECTRUM:Delay:RF Bit Rate:Operating TemperatureStorage TemperatureMinimum IlluminationPower SupplyNight vision distanceWaterproof ratingAudioViewing Angle 0Lux DC10~32V□8~10m □12~15mAuto pairing:1. Choose the channel that needs to be set up, and the monitor display the message“PAIRING START 50” and a counter that counts down 50s.2. Within the countdown, power the camera.3. The monitor and cameras will synchronize themselves with each other after thecamera is powered for 5s.For successful auto pairing, the picture appears. If pairing isunsuccessful, themonitor displays the message “No Signal”. Repeat the pairing procedure. Manually pairing:1. Choose the channel that needs to be set up, and the monitor display the message“PAIRING START 50” and a counter that counts down 50s.2. Press the pairing button on the power-on camera.3. The monitor and cameras will synchronize themselves with each other.For successful auto pairing, the picture appears. If pairing isunsuccessful, themonitor displays the message “No Signal”. Repeat the pairing procedure.IP69K□ Yes □ No□ 120° □ 92°4Mbps–20℃ ~ 70℃, RH95%MAX.–30℃ ~ 80℃, RH95%MAX.17dBm FHSS120ms-89dBmMPEG4PAL: 25f/s NTSC: 30f/sAuto2400-2483.5MHZ120MBetter than 48dBAutoAuto:1/60(NTSC)/1/50(PAL)～1/100,000 Seconds1.0Vp-p, 75Ohm0.45Auto4.6228mm×3.6112mm2:1 InterlaceInternalCAMERA USER MANUAL1/3" CMOS PC1089728×488 pixels
FCC RF Radiation Exposure Statement:This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment shouldbe installed and operated with a minimum distance of 20 centimeters between the radiator and your body.FCC Statement:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, usesand can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference toradio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmfulinterference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Note: Modifications to this product will void the user’s authority to operate this equipment.

Navigation menu