SOLEM TBOSIIADUS Radio Adapter User Manual Manual

SOLEM Radio Adapter Manual

Manual

TechnotesTBOSII ADAPTORR
RF EXPOSUREThis device complies with FCC RF and Industry Canada radiation exposure limits set forth for general population.This device must be installed to provide a separation distance of at least 20cm from allpersons and must not be co-located or operating in conjunction with any other antenna ortransmitter.FCC STATEMENTThe user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate theequipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment o and on, the user is encouraged to try to correct interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on circuit dierent from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.IC STATEMENTRSS Gen / Transmitter Antenna.Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.RSS Gen / User Manual Notice for Licence-Exempt Radio Apparatus.This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.RADIOConformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.NORMES CEM (radio)CE- ETSI EN 300220-2 (V2.1.2-2007/06) et ETSI EN 300220-1 (V2.1.1-2006104) - EN 50371 (2002)- ETSI EN 301 489-1 (V1.8.1-2008/4) et ETSI EN 301 489-3 (V1.4.1-2002108)CANADA- RSS-210 Issue 7- Jun 2007 - RSS-Gen Issue 2- Jun 2007FCC- FCC Part 15, Subpart C 15.247 - ANSI C63.4 (2009)DÉCLARATION DE CONFORMITÉFR - Le produit est destiné à fonctionner dabs un regard fermé, hermétique aux rayons UV.- Etanchéité IP68.EN - The device shall be placed on a closed valve box, isolated from UV.- IP68 sealingES - El producto està pensado para operar en un sitio cerrado y hermético a los rayos UV.- Estanqueidad IP68STATEMENTConformément à la Directive Européenne 2002/96/CE et à la norme EN50419:2005, cet équipement ne doit pas être jeté avec les ordures ménagères.Il doit faire l’objet d’une collecte sélective appropriée an de permettre sa valorisation. Par ce geste, vous contribuerez au respect de l’environnement et à la protection des ressources naturelles.
9V6LR61 - 6AM6 (Duracell, Varta...)2     1
RAIN BIRD EUROPE S.A.R.L900, rue Ampère, BP 7200013792 Aix-en-Provence CEDEX 3 - FRANCE(33) 4 42 24 44 61 - Fax (33) 4 42 24 24 72RAIN BIRD EUROPE INTERNATIONAL, INC145 North Grand AvenueGlendora, CA 91741 - USA  (626) 963-9311 - Fax: (626) 963-428760NOTINEWTBADAPUS - Updated 04-11 www.rainbird.fr / mail : rbe@rainbird.fr

Navigation menu