Sam Nazarko OSMC 2.4G Remote Control User Manual

Sam Nazarko Trading Ltd 2.4G Remote Control Users Manual

User Manual

Sam Nazarko Trading Ltd 2.4G Remote Control Model: OSMC Remote Controller 1.This is 2.4g wireless remote control, include remote control,receiver 2. It will emit 2.4G radio wave when press the buttons,the code single of the buttons will be save in Radio wave,when our receiver receive this radio wave,it will demodulate code signal,then the code signal will converted to standard USB signal output the device,then acheive to control the device. 3. Remote access to electricity, at the same time, press the home button + OK button until the blue LED lights up, insert the USB receiver head need remote terminal equipment USB port, blue leds within just a few seconds after three flashes, the code successfully. At this point you can press the button command terminal. 4. Insert the matching good USB receiver terminal equipment, electric remote control, press the button on the remote control, remote control that can be remote control terminal .To prepare. Keys: 5. The remote control operating voltage: The remote control operating voltage 3V，The battery model ：CR2032.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Navigation menu